Fookin last friday, I did an alignment on a fixture and ran a master part multiple of times, but I didnt like one of the move points, so I inserted a new move point. Somehow the CMM went retarded and drove the probe right into the dam table. Bent the **** out of my 3mm probe and busted the module because it was in A0B0. Has anyone else have had this happen to them? Not even a year old global s green and running 2018R2. 2nd time in a month.
The CMM crashed atthepoint that is highlighted. Even after the crash and I put in a new module and probe/re-calibrated. Moved the probe over to were this move point is using the probe read-outs window. It showed that the Probe should have went to this xyz location given in the code. Since the CMM maintained alignment.
The CMM crashed atthepoint that is highlighted. Even after the crash and I put in a new module and probe/re-calibrated. Moved the probe over to were this move point is using the probe read-outs window. It showed that the Probe should have went to this xyz location given in the code. Since the CMM maintained alignment.
It's not obvious from the picture which tip is active when you do the MOVE - you change tip immediately after, maybe you meant to insert the MOVE after the tip change?
The tip stays at A0B0. I have tip change callouts in the program for different parts. That way I can just do some fine tuning instead of writing a whole prg.