Not really sure where to exactly i should've posted this but its here now. I am recently new to CMM so im still learning alot. That being said I have a slight issue with something im trying to do with my CMM I am trying to do an adaptive circle scan on the OD of a circle Ive gotten it adjusted correctly to the right diameter and depth to check it. When I start the program it makes contact with the part but then starts going away from the part. I think I need like a barrier. Similar to a clearance plane but reverse. Im sure its in PCDMIS and im just not seeing it. Any and all help is appreciated.
The spacer controls how far inboard or outboard of the nominal diameter the plane should be taken. for a hole the value will be a positive one for external diameters it will be a negative one.
You will still need to correct the Z nominal otherwise it will still most likely crash into the part.
The spacer controls how far inboard or outboard of the nominal diameter the plane should be taken. for a hole the value will be a positive one for external diameters it will be a negative one.
You will still need to correct the Z nominal otherwise it will still most likely crash into the part.