i use the same setup as DAN_M showed and i love them! i can get to places that i can't normally get with standard setups
I even had my CNC Dept grind off the bottom of the star (part that sticks out in the pic) . Now there is only a very small lip I can grab with some needle nose plyers if I want to tighten it, but it allows me to pretty much almost bottom out that probe and get really deep into an ID
i use the same setup as DAN_M showed and i love them! i can get to places that i can't normally get with standard setups
I even had my CNC Dept grind off the bottom of the star (part that sticks out in the pic) . Now there is only a very small lip I can grab with some needle nose plyers if I want to tighten it, but it allows me to pretty much almost bottom out that probe and get really deep into an ID
