Anyone running verisurf on the cmm or equator? Pros cons?
My company is not loving or believe pcdmis is giving correct data. I hear at least 3 times a day math is math and pcdmis is not doing the math correctly.
Is the machinist actually using the primary surface as the " level " ? You see this all the time. Do 1 side of part check a hole in z then tip it on side and do the same. Well you just leveled to 2 separate surfaces. That only works in well CAD. On a real part it will not. Unless of course the surfaces are square to to each other with 0.0 error. So again. NOPE. When you explain that to them they might understand.
Is the machinist actually using the primary surface as the " level " ? You see this all the time. Do 1 side of part check a hole in z then tip it on side and do the same. Well you just leveled to 2 separate surfaces. That only works in well CAD. On a real part it will not. Unless of course the surfaces are square to to each other with 0.0 error. So again. NOPE. When you explain that to them they might understand.
