I was running a part that has had a old program on it on a global s 9.15.9 chrome. I found it oot. I was told that part has to be ran on the 7.10.7 global advantage. So I did and found it to be good. Same part same program same head and porbes. Why would this part run good on 1 machine and not on the other? I can run other parts to within a couple tenths of each other on both machines but not this one.
Do both machines have the same probe body? (TP200, TP20, hp-s-x1h, etc)
It might have something to do with fast probe mode. The analog scanning heads (hp-s-x1h) can use more force than a normal TTP like the TP20 or TP200.
You could try turning on fast probe mode at the top of the program and run it again on both machines.
Also just a heads up, fast probe mode is supposedly less accurate (I have never done a study so IDK)
Do both machines have the same probe body? (TP200, TP20, hp-s-x1h, etc)
It might have something to do with fast probe mode. The analog scanning heads (hp-s-x1h) can use more force than a normal TTP like the TP20 or TP200.
You could try turning on fast probe mode at the top of the program and run it again on both machines.
Also just a heads up, fast probe mode is supposedly less accurate (I have never done a study so IDK)
