Your Products have been synced, click here to refresh
Don't think. There are numerous ways and reasons to skip a manual alignment.
When done properly, it is not an issue.
Are you probing the same features in the manual alignment and DCC alignment?
Looking at your code says no.
Scratch that. Looks like they are the same features.
Take the move point out.
Put the probe where you want the move point to be.
Create a new move point at that spot.
I think you are trying to make the probe move through the part.
Don't think. There are numerous ways and reasons to skip a manual alignment.
When done properly, it is not an issue.
Are you probing the same features in the manual alignment and DCC alignment?
Looking at your code says no.
Scratch that. Looks like they are the same features.
Take the move point out.
Put the probe where you want the move point to be.
Create a new move point at that spot.
I think you are trying to make the probe move through the part.
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |