I have a script that changes the alignment offset values.
but when I run it it changes the theoretical values of all points.
what should I change in my script so that it doesn't change the nominals of the points?
I copied and tested your script,
I don't see the behavior you describe in my case.
the script changes the offset values as desired, but at the same time the nominal values are
not updated on all subsequent commands.
this probably means that in your measurement routine the message "update nomials" is set to yes as the default.
I copied and tested your script,
I don't see the behavior you describe in my case.
the script changes the offset values as desired, but at the same time the nominal values are
not updated on all subsequent commands.
this probably means that in your measurement routine the message "update nomials" is set to yes as the default.
