I can't say that I am seeing that not to say that I am not doing something wrong however. The one concern I have with that is, does it report the hole as being closer in each axis? i.e. on the report does it shorten the basic number it is reporting to compensate for the added tolerance?
It will do so in the amount and direction that it was able to shift the part and stay on the pins.
ONE THOUGHT! I heard someone say that if a hole is OVER SIZE (bigger than it is allowed to be) that SOME versions of Pcdmis will NOT give you any bonus tolerance for that MMC, even though you SHOULD still get it. Being over-sized does NOT alter the fact that SOME of that size deviation is STILL your bonus.
I can't say that I am seeing that not to say that I am not doing something wrong however. The one concern I have with that is, does it report the hole as being closer in each axis? i.e. on the report does it shorten the basic number it is reporting to compensate for the added tolerance?
It will do so in the amount and direction that it was able to shift the part and stay on the pins.
ONE THOUGHT! I heard someone say that if a hole is OVER SIZE (bigger than it is allowed to be) that SOME versions of Pcdmis will NOT give you any bonus tolerance for that MMC, even though you SHOULD still get it. Being over-sized does NOT alter the fact that SOME of that size deviation is STILL your bonus.
