Alignment to offset holes?

Hi all. First post. Sorry if it's a rookie question.

I want to do a Plan-Circle-Circle alignment.
The first hole is the x0 y0 origin.
The second hole has some given coordinates, say x8.0, y4.0.

I don't want to have to calculate the angle and use the "Offset angle" in the "Rotate to" field.
I also don't want to use an iterative alignment.

Any ideas?

Thanks,
Steve

Parents

Dan Denlinger over 14 years ago

I get that. The dowels used from rotation above are not in line.

DIM LOC93= LOCATION OF CIRCLE DOWEL1 UNITS=IN ,$
GRAPH=OFF TEXT=OFF MULT=1.00 OUTPUT=BOTH
AX MEAS NOMINAL +TOL -TOL DEV OUTTOL
X 0.0000 0.0000 0.0006 0.0006 0.0000 0.0000 ----#----
Y 0.0000 0.0000 0.0006 0.0006 0.0000 0.0000 ----#----
D 0.2506 0.2500 0.0010 0.0010 0.0006 0.0000 ------#--
END OF DIMENSION LOC93
DIM LOC94= LOCATION OF CIRCLE DOWEL2 UNITS=IN ,$
GRAPH=OFF TEXT=OFF MULT=1.00 OUTPUT=BOTH
AX MEAS NOMINAL +TOL -TOL DEV OUTTOL
X -2.2500 -2.2500 0.0006 0.0006 0.0000 0.0000 ----#----
Y 3.0080 3.0080 0.0006 0.0006 0.0000 0.0000 ----#----
D 0.2504 0.2500 0.0010 0.0010 0.0004 0.0000 ------#--
END OF DIMENSION LOC94
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Dan Denlinger over 14 years ago

I get that. The dowels used from rotation above are not in line.

DIM LOC93= LOCATION OF CIRCLE DOWEL1 UNITS=IN ,$
GRAPH=OFF TEXT=OFF MULT=1.00 OUTPUT=BOTH
AX MEAS NOMINAL +TOL -TOL DEV OUTTOL
X 0.0000 0.0000 0.0006 0.0006 0.0000 0.0000 ----#----
Y 0.0000 0.0000 0.0006 0.0006 0.0000 0.0000 ----#----
D 0.2506 0.2500 0.0010 0.0010 0.0006 0.0000 ------#--
END OF DIMENSION LOC93
DIM LOC94= LOCATION OF CIRCLE DOWEL2 UNITS=IN ,$
GRAPH=OFF TEXT=OFF MULT=1.00 OUTPUT=BOTH
AX MEAS NOMINAL +TOL -TOL DEV OUTTOL
X -2.2500 -2.2500 0.0006 0.0006 0.0000 0.0000 ----#----
Y 3.0080 3.0080 0.0006 0.0006 0.0000 0.0000 ----#----
D 0.2504 0.2500 0.0010 0.0010 0.0004 0.0000 ------#--
END OF DIMENSION LOC94
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data