I am measuring a feature that is somewhat round but has lot of jagged edges. I want to use all of the areas to calculate the area. I am measuring this using hundreds of points. Anyone have any ideas ? I have searched for answers but can't seem to come up with any.
RandomJerk Not sure if that could be done on a mass scale, automated, and executed through pcdmis with my skill level lol.
JEFMAN anOops, here is my application for this:
Non-circular. I thought about adding a calculation for compositing all the geometries by size but i think there would be too much error.
I probably should have mentioned a bit more context, the solution desalo presented seemed elegant for the problem - i just can't get it to work. I tried reducing the point count for troubleshooting and still produced zeros. I may plug some dummy values and try again. I was going to equate the area of this shape minus it's internal shapes.
AndersI The blob says it needs to fit within the field of view, but I'll try to force it to work and see if it'll work.
RandomJerk Not sure if that could be done on a mass scale, automated, and executed through pcdmis with my skill level lol.
JEFMAN anOops, here is my application for this:
Non-circular. I thought about adding a calculation for compositing all the geometries by size but i think there would be too much error.
I probably should have mentioned a bit more context, the solution desalo presented seemed elegant for the problem - i just can't get it to work. I tried reducing the point count for troubleshooting and still produced zeros. I may plug some dummy values and try again. I was going to equate the area of this shape minus it's internal shapes.
AndersI The blob says it needs to fit within the field of view, but I'll try to force it to work and see if it'll work.
