tcp/ip port setting

I am having trouble connecting to my DEA controller on my Global.
Using rs-232 connection I was able to use hyper terminal to show the connections.

READY
SHOW TCPIP
TCP/IP Information

Ctrl Internet Address : 80.128.0.2
Port Number : 0
Host Internet Address : 80.128.0.1
Connection State : listening
Bad IP Checksums : 0
Bad TCP Checksums : 0
Packets Retransmitted : 0

Is there a way to change the port setting remotely? It should be set to 2001, but as you see it is 0 now. The motherboard was changed recently in the controller.

Parents

JEFMAN over 12 years ago

I'm not at the cmm, but i think you can change 2001 by 0 in PC-DMIS (config CMM Window, just where you type TC-PIP adress). You're right, when you do a "show tcpip", it returns the controller config. You just have to configure settings off pc_dmis to make it work...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

JEFMAN over 12 years ago

I'm not at the cmm, but i think you can change 2001 by 0 in PC-DMIS (config CMM Window, just where you type TC-PIP adress). You're right, when you do a "show tcpip", it returns the controller config. You just have to configure settings off pc_dmis to make it work...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data