hexagon logo
Register Sign in
  • Replies 22 replies
  • Subscribers 224 subscribers
  • Views 582 views
  • Users 0 members are here
Options
Related

tcp/ip port setting

Andy F.
I am having trouble connecting to my DEA controller on my Global.
Using rs-232 connection I was able to use hyper terminal to show the connections.

READY
SHOW TCPIP
TCP/IP Information

Ctrl Internet Address : 80.128.0.2
Port Number : 0
Host Internet Address : 80.128.0.1
Connection State : listening
Bad IP Checksums : 0
Bad TCP Checksums : 0
Packets Retransmitted : 0

Is there a way to change the port setting remotely? It should be set to 2001, but as you see it is 0 now. The motherboard was changed recently in the controller.
Parents
  • This is what I have...no warranty implied.

    Go to Control Panel
    Network Connections
    LAN
    Properties
    Then…
    Highlight TCP/IP
    Then…
    Properties
    Choose radio button tha says “use following IP ADDRESS”
    Type in at IP… 80.128.0.1 ---I used 204.17.113.168
    Type in at subnet…255.255.0.0
    Under LAN…
    Properties
    General Tab
    Configure
    Advanced Tab
    Speed & duplex = 10mb FULL


    Within PC-DMIS…

    Machine Interface Setup
    Use TCp/IP link to drive Machine
    TCP/IP Address= 80.128.0.2 ---I used 204.17.113.169
    TCP/IP Port Number= 2001




    FWIW....I just went through this yesterday on my new PC. The above settings didn't work for me. I went back to the old PC and looked up the IP it had on it.

    See my two changes in RED above.

    I also agree the subnet should be 255.255.255.0
Reply
  • This is what I have...no warranty implied.

    Go to Control Panel
    Network Connections
    LAN
    Properties
    Then…
    Highlight TCP/IP
    Then…
    Properties
    Choose radio button tha says “use following IP ADDRESS”
    Type in at IP… 80.128.0.1 ---I used 204.17.113.168
    Type in at subnet…255.255.0.0
    Under LAN…
    Properties
    General Tab
    Configure
    Advanced Tab
    Speed & duplex = 10mb FULL


    Within PC-DMIS…

    Machine Interface Setup
    Use TCp/IP link to drive Machine
    TCP/IP Address= 80.128.0.2 ---I used 204.17.113.169
    TCP/IP Port Number= 2001




    FWIW....I just went through this yesterday on my new PC. The above settings didn't work for me. I went back to the old PC and looked up the IP it had on it.

    See my two changes in RED above.

    I also agree the subnet should be 255.255.255.0
Children
No Data
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement