Well, that may be the case. We have no problems calibrating our 2mm cylinder probe. We also back up our results with manual methods (gage pins, micrometers, etc.) and the measurements are always the same.
Could you please provide some information that says cylinder probes can't be calibrated?
just search cylinder or shank probes there are tons of threads on here explaining why. I think I even have a couple of threads myself on this subject. I use to check dovetail o ring grooves with a shank probe untill I realized the uncertainty of using them.
Well, that may be the case. We have no problems calibrating our 2mm cylinder probe. We also back up our results with manual methods (gage pins, micrometers, etc.) and the measurements are always the same.
Could you please provide some information that says cylinder probes can't be calibrated?
just search cylinder or shank probes there are tons of threads on here explaining why. I think I even have a couple of threads myself on this subject. I use to check dovetail o ring grooves with a shank probe untill I realized the uncertainty of using them.
