Extracting assignments from fcf's that hold multiple features

Hi there
I have a single feature control frame that tolerances 31 holes (FCFLOC15) I would like to extract each holes deviation from nominal position via assignments to do this normally I would
use the following assignment "ASSIGN/V1=FCFLOC15.Z.DEV" the only trouble is this only gives the deviation for the 1st hole in FCFLOC15 how if possible can you extract the other
30 'Z' deviations is there some sort of extension to go after the FCFLOC15 ?
Regards Tim.

Parents

TIMSHARMAN over 10 years ago

Thanks for the reply but not had a lot of joy with this I have reverted back to using legacy dimensions and tolerancing each feature separately. surely there is an easier way than this I have also spoke to hexagon (UK) and they don't know of any way of doing this they are going to speak to Wilcox to see if they know ? I will post any updates that I receive to share the knowledge.
Thanks Tim.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

TIMSHARMAN over 10 years ago

Thanks for the reply but not had a lot of joy with this I have reverted back to using legacy dimensions and tolerancing each feature separately. surely there is an easier way than this I have also spoke to hexagon (UK) and they don't know of any way of doing this they are going to speak to Wilcox to see if they know ? I will post any updates that I receive to share the knowledge.
Thanks Tim.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data