Extracting assignments from fcf's that hold multiple features

Hi there
I have a single feature control frame that tolerances 31 holes (FCFLOC15) I would like to extract each holes deviation from nominal position via assignments to do this normally I would
use the following assignment "ASSIGN/V1=FCFLOC15.Z.DEV" the only trouble is this only gives the deviation for the 1st hole in FCFLOC15 how if possible can you extract the other
30 'Z' deviations is there some sort of extension to go after the FCFLOC15 ?
Regards Tim.

Parents

romeom over 6 years ago

Where can I find those numbers inside parentheses like in this example 662? Where is list of this code meaning?, Thanks
I have composite true position dimension and I need two TP simension, one of them is ...GETTEXT(662, ....) but I can't find for other part of composite TP which code is right
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

romeom over 6 years ago

Where can I find those numbers inside parentheses like in this example 662? Where is list of this code meaning?, Thanks
I have composite true position dimension and I need two TP simension, one of them is ...GETTEXT(662, ....) but I can't find for other part of composite TP which code is right
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data