Fixture moved

Hello,
I will just get right to the point. I had to make my fixture higher up off the stone. I have already made the program. But, now that I have moved the fixture, when the program gets to DCC mode, it keeps going back to where the fixture was. How do I measure the manual alignment to change to the new height?

Parents

bfire85 over 10 years ago

Make sure your manual alignments are not highlighted (marked) and run the manual alignment again. This will "find" your part in the new location. Make sure setup instructions are changed accordingly. Then unmark your manual alignments if that is the process you choose at your facility. Otherwise do what John said and do a flow control with labels.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

bfire85 over 10 years ago

Make sure your manual alignments are not highlighted (marked) and run the manual alignment again. This will "find" your part in the new location. Make sure setup instructions are changed accordingly. Then unmark your manual alignments if that is the process you choose at your facility. Otherwise do what John said and do a flow control with labels.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data