I have been running into problems using 2014 where it seems like I am getting a backlog of information being used when it shouldn't be. Example: I program a part, very straight forward alignment, A-top plane, B- Line, C-cylinder...theses are used for both manual and DCC alignment. Now I check the true position on several holes using legacy dimensioning and the numbers look good. I take said part of and put on part two, part number two's true position numbers have doubled, part three's position numbers have doubled from part two's, and so on and so fourth. Has anyone run into this occurrence? And if so, what have you done to fix it?
Are you executing from the cursor (ctrl+u) or executing from the start (ctrl+q)
(ctrl+q)
I will try the clear template data on my next run, it will be a couple days though with Hexago here for calibration. Will update when I am able to do so. Thanks for the ideas guy's.
Are you executing from the cursor (ctrl+u) or executing from the start (ctrl+q)
(ctrl+q)
I will try the clear template data on my next run, it will be a couple days though with Hexago here for calibration. Will update when I am able to do so. Thanks for the ideas guy's.
