Command Argument Out of Limit Emergency Error

I am having issue with a stubborn error message "Command Argument Out of Limit"

The program errored out with a similar message in the Z (which was odd because the part was moving X-Y at 90, 90). So I recalibrated probe and received the same message after the head rotated from 90, -90 to 90, 90.

After a machine restart, the error is coming up after homing the machine and cannot do anything else.

Any help?

Parents

DaSalo over 8 years ago

I suspect that you could get this error when attempting pass any value to the controller that is outside of the acceptable range for that parameter. In A.Morales' case it was the value for the low force parameter but it could just as easily have been some other parameter. The debug file should allow you to identify exactly what was being passed to the controller at the instant that the error was triggered so you won't have to go hunting through hundreds of parameters looking for the culprit.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

DaSalo over 8 years ago

I suspect that you could get this error when attempting pass any value to the controller that is outside of the acceptable range for that parameter. In A.Morales' case it was the value for the low force parameter but it could just as easily have been some other parameter. The debug file should allow you to identify exactly what was being passed to the controller at the instant that the error was triggered so you won't have to go hunting through hundreds of parameters looking for the culprit.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data