I am new guy for this user forum, currently I am using PC-DMIS in Camio 8.3. (Nikon Make)
Recently, I found a problem with a alignment issue for my product. It is about a alignment of [A-B I C I D-E ] of part. Please refer to attached file for details. In that A & B are the circles through which we are going to construct a 3S line as a primary datum, then moving ahead C is plane as a secondary datum and lastly D & E are tooth width, from which we need to construct a line through theirs mid points. As in that I don't understand how to do alignment of this part ?
Because there are 2 lines and 1 plane. and mostly unluckily axis of 3D line and Plane is same. Its conflicts my alignment. CAMIO is not allowing me to add 2 line 1 plane alignment anyway.
I am new guy for this user forum, currently I am using PC-DMIS in Camio 8.3. (Nikon Make)
Recently, I found a problem with a alignment issue for my product. It is about a alignment of [A-B I C I D-E ] of part. Please refer to attached file for details. In that A & B are the circles through which we are going to construct a 3S line as a primary datum, then moving ahead C is plane as a secondary datum and lastly D & E are tooth width, from which we need to construct a line through theirs mid points. As in that I don't understand how to do alignment of this part ?
Because there are 2 lines and 1 plane. and mostly unluckily axis of 3D line and Plane is same. Its conflicts my alignment. CAMIO is not allowing me to add 2 line 1 plane alignment anyway.
