is there any way to skip hole on a cone that has flats on it? i cant get it to rotate around even when i modify the start and end angles. Also, the path lines dont match the measurement strategy. not sure what exactly is going on, maybe i am doing something wrong? I am trying to do an analog scan.
daberger I am using 2015.1 I seen this happen a few times on there. Most of the time it happened when I had 2 programs up, not saying this is the case. But I would do like Josh said try creating a new one.
daberger I am using 2015.1 I seen this happen a few times on there. Most of the time it happened when I had 2 programs up, not saying this is the case. But I would do like Josh said try creating a new one.
