Your Products have been synced, click here to refresh
I'm trying to use Equate as described above, spinning the part 180 degrees (fixture plate, repeatable locations) in X/Y.
...Nice flat bottom part.
I finish the 1st half, spin the part, and re-probe the same ABC features. (2 planes constructed from V-pts and a circle)
Then I build the new alignment and hit Equate.... And nothing happens... that I can see.
I am expecting to see the change in the graphics window. Can one of you Equate gurus tell me what I'm doing wrong.
And a side question... Is a switch into manual mode necessary?
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |