I was wondering if there was a way to rename features after all features have been created. I like to write my offline programs using individual Auto Vector Points and then I will build features like planes and lines (for example) after everything is created. A common problem I run into is I'll forget to put a point into a certain location. So I'll go back and insert a point where I want but since I've created 30 points after this location the new point I create will not be in numerical order. Is there a way I can tell PC-DMIS to rename all points to numerical order? Hope this makes sense. I've attached a screen shot as an example.
Anders, the reason why I sometimes run into this problem is because every feature I create in my program doesn't always have a special label like "CIR.250_1". To be honest, a lot of the time I don't even change the labels at all and just keep whatever PC-DMIS gives me. Of course, I make up for this in my reporting. When I output I put in a little extra time putting in comments above the output feature that explains the feature, whether it's a balloon number or just info like "CIR.250_1 (ZONE B4, SHEET1).
Anders, the reason why I sometimes run into this problem is because every feature I create in my program doesn't always have a special label like "CIR.250_1". To be honest, a lot of the time I don't even change the labels at all and just keep whatever PC-DMIS gives me. Of course, I make up for this in my reporting. When I output I put in a little extra time putting in comments above the output feature that explains the feature, whether it's a balloon number or just info like "CIR.250_1 (ZONE B4, SHEET1).
