I would use a 0.5" ball, and try to use the sigle point circle.
On a cylindrical part Ø5, the diference of height between the highest point and the lowest point of a hole Ø0.25 is 0,04 mm (0,0015").
I believe that the uncertainty has approximately the same value on a Romer, I think you can do it by this way.
I would use a 0.5" ball, and try to use the sigle point circle.
On a cylindrical part Ø5, the diference of height between the highest point and the lowest point of a hole Ø0.25 is 0,04 mm (0,0015").
I believe that the uncertainty has approximately the same value on a Romer, I think you can do it by this way.
