Take the part you need to check and all the gages that you currently use , place them in a clean and calibrated box then dump them on the table of the CMM all at one time. Then "read" the pile that you just created like an old shaman sooth sayer would do with the entrails of an animal sacrifice. Document your findings and repeat with the next part.
Seriously, this forum can help you but from the sounds of it I'm not sure if you're ready for any help that we can give.
Take the part you need to check and all the gages that you currently use , place them in a clean and calibrated box then dump them on the table of the CMM all at one time. Then "read" the pile that you just created like an old shaman sooth sayer would do with the entrails of an animal sacrifice. Document your findings and repeat with the next part.
Seriously, this forum can help you but from the sounds of it I'm not sure if you're ready for any help that we can give.
