Hi, all. today i did run my calibration program and everyting seemed good, but after the first exchange of probes i reicive error message "TR_PRB01,no Probing within Probelimit !"
to me it`s odd, because i did run the calibration program for a while ago.
i tried to jump over the probe wich have this problem, and 3 of 6 probes are running throug without any problems.
so far i`ve been checking the probes and they are all in the same condition as it was the last time i performed a calibration.
if it helps, i run PC-DMIS 2016
in advance thank you all.
