Good evening,
What is the best way to measure threads on the CMM? I would just use a thread gage and put it in the report but I was asked to write them in the program. Thank you in advance.
When it comes to reporting true position of threads do you leave out the dia of the thread? If you do report the dia what is the tolerance? Do you just use the nominal dia pcdmis comes up with? There are a few different ways that people have programmed threads. Some left the dia out and just reported the position and some reported the dia with a tolerance. I just cant seem to figure out how they came up with a dia and tolerance.
When it comes to reporting true position of threads do you leave out the dia of the thread? If you do report the dia what is the tolerance? Do you just use the nominal dia pcdmis comes up with? There are a few different ways that people have programmed threads. Some left the dia out and just reported the position and some reported the dia with a tolerance. I just cant seem to figure out how they came up with a dia and tolerance.