Good evening,
What is the best way to measure threads on the CMM? I would just use a thread gage and put it in the report but I was asked to write them in the program. Thank you in advance.
I only report the position when measuring threads. To many form variables like burrs and debris that will report inaccurately in regard to the major/minor diameters. Thread gauge, Pins etc. are the only way to report size in my opinion.
Always ensure your pitch is set properly as well
I only report the position when measuring threads. To many form variables like burrs and debris that will report inaccurately in regard to the major/minor diameters. Thread gauge, Pins etc. are the only way to report size in my opinion.
Always ensure your pitch is set properly as well
