DCC alignment not automatically following manual alignment

Hello all,

I'm new to PC DMIS and I'm having an issue where it seems like my manual alignment is not properly telling my DCC alignment where the features are.

I'll get a program up and running, and then I have to move the part to a different location on the table for one reason or another.

I run another manual alignment, go to run the program, and it doesn't work.

I was able to resolve the problem by re-setting my initial alignment and updating the dependent features, but my understanding is that I shouldn't have to do this every time and that it should do it automatically.

what am I missing here?

Parents

A-machine-insp over 4 years ago

So I should re-measure all features after the DCC alignment and only dimension off of those, even if I measured those features in DCC mode before the DCC alignment?

YES!!!!!!!! Never dimension to features used in your alignment!!!!!

I have a guy here who will dimension to hits taken in his manual alignment.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Douglas over 4 years ago in reply to A-machine-insp

There are still a few programs here that do that exactly, nobody in the past understood and now nobody but me is convinced it is incorrect.... slightly concave face threw position results off .030" but no problem we can run that I'm told... and don't get me going on BS feature nominals taken in learn mode while they made the program
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Douglas over 4 years ago in reply to A-machine-insp

There are still a few programs here that do that exactly, nobody in the past understood and now nobody but me is convinced it is incorrect.... slightly concave face threw position results off .030" but no problem we can run that I'm told... and don't get me going on BS feature nominals taken in learn mode while they made the program
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data