hexagon logo
Register Sign in
  • Replies 5 replies
  • Subscribers 221 subscribers
  • Views 147 views
  • Users 0 members are here
Options
Related

report evaluation

jigars
I came across a note on drawing which says
50% of the holes may exceed the drawing by 0.0003
10% of the holes may exceed the drawing by 0.005 if each of these are separated by at least (5) holes no more than 0.0003 over max
this needs to be checked for a set of 24 equi spaced holes, is there any way to check & report this ?
Parents
  • That has to be the worst drawing note I've ever heard of. Lol... 10% of 24 is 2.4 so how in the heck are you going to have .4 holes?

    I know a machinist that is a drill and tap breaking savant. I've seen .4 of a hole and even a few 1.4 of a hole.

    Seriously though, I believe you would have to assign each deviation to a variable then tally the variables based on your criteria and report that. I've never done anything that complex in PC DMIS but I have in other programming languages. I'm sure a few of the guys on here know how to do it, I'm just not that fluent in PC DMIS yet.
Reply
  • That has to be the worst drawing note I've ever heard of. Lol... 10% of 24 is 2.4 so how in the heck are you going to have .4 holes?

    I know a machinist that is a drill and tap breaking savant. I've seen .4 of a hole and even a few 1.4 of a hole.

    Seriously though, I believe you would have to assign each deviation to a variable then tally the variables based on your criteria and report that. I've never done anything that complex in PC DMIS but I have in other programming languages. I'm sure a few of the guys on here know how to do it, I'm just not that fluent in PC DMIS yet.
Children
No Data
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement