I have a Mitutoyo BN1015 with PH20 and UCC T5. Running 2018R1. Will change to angle in DCC program but before it measures drops back to A0B0. Just getting started with programming with this setup. All works fine with A0B0.
Something I'm not understanding is why your tip commands have "_T5" at the end of each. It makes me wonder if that Tip selection isn't understood and so it defaults to A0B0?
Something I'm not understanding is why your tip commands have "_T5" at the end of each. It makes me wonder if that Tip selection isn't understood and so it defaults to A0B0?
I have six probe assemblies showing in server. T5 is the main one I use. So if I use the same angle with assembly T4 I want to be able to differentiate.