I have a Mitutoyo BN1015 with PH20 and UCC T5. Running 2018R1. Will change to angle in DCC program but before it measures drops back to A0B0. Just getting started with programming with this setup. All works fine with A0B0.
Does this identification work else where? I would imagine that since the software is built to differentiate already, your redundancy is causing the issue.
Does this identification work else where? I would imagine that since the software is built to differentiate already, your redundancy is causing the issue.
I++ uses a direct naming convention. So for example all probes are built and calibrated in Renishaw UCC software, then you assign a nickname in Renishaw software, then in PC-DMIS you assign than nickname through the probe edit window. It's a whole different beast unfortunately. Tool names can be pretty much what ever you want them to be and tend to be incredibly goofy looking to someone not aware.
