Good morning, attached is a pic I wanted to get some feedback on. I wanted to see what the best Alignment would be. Its a bent Part. Any Advice would be great. Thank you.
left 4 points 25x25mm (Y-475), right 4 points 25x25mm (Y+475). these 8 points are now "base A" as a plane.
are these holes made perpendicular to A ?
if so, you have to probe a circle out of ZPlus and move the points on one side maybe 1-2mm in z.
(with a "measured circle" this can easily be adjusted.)
left 4 points 25x25mm (Y-475), right 4 points 25x25mm (Y+475). these 8 points are now "base A" as a plane.
are these holes made perpendicular to A ?
if so, you have to probe a circle out of ZPlus and move the points on one side maybe 1-2mm in z.
(with a "measured circle" this can easily be adjusted.)