Good morning, attached is a pic I wanted to get some feedback on. I wanted to see what the best Alignment would be. Its a bent Part. Any Advice would be great. Thank you.
I think you ignore that Datum A symbol flagged to an unclear surface on the left. I think that is trying, very poorly, to indicate the surface the A datum targets are on.
I would use the Datum A targets to make the A Datum, then rotate hole B through Slot C.
But if this is a bent part, maybe you have Datum Targets for B and C somewhere, indicating to use an iterative alignment.
I think you ignore that Datum A symbol flagged to an unclear surface on the left. I think that is trying, very poorly, to indicate the surface the A datum targets are on.
I would use the Datum A targets to make the A Datum, then rotate hole B through Slot C.
But if this is a bent part, maybe you have Datum Targets for B and C somewhere, indicating to use an iterative alignment.
