Is it possible to use separate custom reports inside the one program?
I need to measure some bits of a part and/or other bits dependent on what the operator choice is at the start of the program and need to show clear Cad views with dimensions attached for each situation, which a custom report works well with. Can I call them into a program at different locations etc...?
Or is there some form of legacy or hyper report that I could do this with? TIA
Here print 1st part ends. I change alignment to 2nd part and repeat structure like in 1st part.
Variable of course must have different name. Custom reports name is "RH"
You can repeat this as many part you want in program. I use basic dialog at beginning of program with part selector and I use If/end if to run selected program.
I can share full program prg if you want but you need to tell me your pcdims version.
Here print 1st part ends. I change alignment to 2nd part and repeat structure like in 1st part.
Variable of course must have different name. Custom reports name is "RH"
You can repeat this as many part you want in program. I use basic dialog at beginning of program with part selector and I use If/end if to run selected program.
I can share full program prg if you want but you need to tell me your pcdims version.