2022.2 Is it normal for this version in Geo Tol. that when you have a bonus that when the part is good, it shows the bonus, and when it shows bad it shows no bonus? I'll check back tomorrow for responses.
Thank you Neil, I will try to mess with it, I have been pulled off of this job, to continue on with something else so I will get back to this when I can, to see if I have some sort of update.
Both are ID's. Callout is actually knda of dumb and not necessary. The datum "E" is on the opposite side, "G" is the same axis, I'll try to draw a picture to explain.
There are 2 mating parts that go in here a nipple with a flat surface that actually has 4 screw holes on "E" so I get a position callout from "G" back to "E" which they have, Then they call the feature back to "E" and "G" which has a different mating part coming from the other side, They said they want it to be perpendicular to "E" that's why they call it that way, I told them it should be parallel or position to "G"
"E" doesn't control anything with the feature nor does it tie into it. but there will be a screw down the middle from the feature side that ties into "G" nothing tying it into "E"