-Measure top plane as TOP_PLN and measure the od cone as OD_CON. Make alignment to plane (Z) and cone(XY).
-Use PC DMIS small arc method to find radius
Once radius is found...
-RECALL main alignment (TOP_PLN & OD_CON)
-Measure probe a line going UP the cone and Y0
-Rotate to nominal angle of the line
-Recall correct workplane
-DIST dim from Y0 line to radius
-Measure top plane as TOP_PLN and measure the od cone as OD_CON. Make alignment to plane (Z) and cone(XY).
-Use PC DMIS small arc method to find radius
Once radius is found...
-RECALL main alignment (TOP_PLN & OD_CON)
-Measure probe a line going UP the cone and Y0
-Rotate to nominal angle of the line
-Recall correct workplane
-DIST dim from Y0 line to radius