I want to see with everyone's expertise on how I should set up this alignment off the Datums. There is Datum Target A1 and A2. and Datum B. How should I Tackle this? Attached is a layout of the Datums. Thank you for any help.
Would this be the first alignment in your program? If so, tubes can be very difficult on the initial alignment. I generally do an iterative alignment first for the machine to find the part, then continue with what R2 is telling you above for the 2nd Alignment. It just works easier for me than figuring out what PCDMIS is trying to do.
Would this be the first alignment in your program? If so, tubes can be very difficult on the initial alignment. I generally do an iterative alignment first for the machine to find the part, then continue with what R2 is telling you above for the 2nd Alignment. It just works easier for me than figuring out what PCDMIS is trying to do.
