In PROFILE OF A LINE when I click to add a second tier, the ADD DATUM disappears if I did not add one .
I want to do a per unit tolerance. once I select a scan it wants datum's. I select a datum and then cannot create a per unit tolerance.
We only support per-unit profile when no datums are referenced. Once you add datums to the upper segment, it becomes a composite profile call-out.
This has been the established behaviour since the introduction of the geometric tolerance command in 2020 R2.
That's great, but it does not work without datums either unless It does not like the feature??? Advanced scan..??
AND, even if you try to correct the call-out while the window is open it loses the functionality to add PER UNIT...
We only support per-unit profile when no datums are referenced. Once you add datums to the upper segment, it becomes a composite profile call-out.
This has been the established behaviour since the introduction of the geometric tolerance command in 2020 R2.
That's great, but it does not work without datums either unless It does not like the feature??? Advanced scan..??
AND, even if you try to correct the call-out while the window is open it loses the functionality to add PER UNIT...
