Good evening Pcdmis masters, I`m fairly new to Pcdmis, and i would love to get some help , I am trying to measure a Countersink Dia at the intersection of the top surface on this part, the available area is very limited and the thread leads are not clocked to the model to get an auto cone reading accurately, is there any method i can use to first identify the rotation of the the double lead thread and then construct a cone avoiding the thread lead`s in order to get an accurate reading? any tips will be appreciated ,thanks in advance
I think you have to add the angle tip (like "T1A0B0") in the probedata assignment.
As V1 and V2 are 0, nan is logicical, because you can't divide by 0. !
I think you have to add the angle tip (like "T1A0B0") in the probedata assignment.
As V1 and V2 are 0, nan is logicical, because you can't divide by 0. !
i think i`m a step closer ,with this instructions i was actually able to extract the right probe data, my center after the last changes in now .191 awful ,but i`m still positive this can be done with the right ball sizes, i`m getting a nominal result on that top circle of 3.6 when is supposed to be 3.3 , but i think if i`m able to construct a generic cone and then intersected to the top surface with circle it will be more accurate.thanks again for all of your help
