I have created a cylinder and a plane running parallel to the cylinder centerline. I want to create a line where the plane intersects the outside of the cylinder, on one side only. How can I do this?
Insert Generic feature>Set to line, update nominal/meas information as desired.
Then you could pierce your cylinder to gain the point references. Once you have 2 points created, you could construct the line you are looking for.
Glad you got what you were looking for, what did you end up doing?
Insert Generic feature>Set to line, update nominal/meas information as desired.
Then you could pierce your cylinder to gain the point references. Once you have 2 points created, you could construct the line you are looking for.
Glad you got what you were looking for, what did you end up doing?