Iterative Alignment issue

I have a part I have to do a iterative alignment on but the print only has 3A,1B, & 1C targets. The rotation is just 1 point on the top of the part on a plane lined up to the centerline of a cylinder on the opposite side. The plane is also called out as the B datum for a True position. Documents are controlled so I can't share it but is there anyway to rotate with only 1 target before I tell them they need to fix the print?

Thanks

Parents

Shadowpaw over 1 year ago

Here is a quick sketch
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
BIGWIG7 over 1 year ago in reply to Shadowpaw

and what kind of tolerances are we talking about here? IMO, and i admit this is my opinion and my opinion only and other may differ. If this is a casting, and it is unmachined, and the tolerances are wide open, I'm taking a few liberties on how I evaluate this part, and that includes possibly adding a few more hits to establish datums and alignments more clearly that what the print suggests. And then I move on with life.

If you are still hesitant to do this, then bring it up to your superiors and ask for suggestions on how to move forward.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

BIGWIG7 over 1 year ago in reply to Shadowpaw

and what kind of tolerances are we talking about here? IMO, and i admit this is my opinion and my opinion only and other may differ. If this is a casting, and it is unmachined, and the tolerances are wide open, I'm taking a few liberties on how I evaluate this part, and that includes possibly adding a few more hits to establish datums and alignments more clearly that what the print suggests. And then I move on with life.

If you are still hesitant to do this, then bring it up to your superiors and ask for suggestions on how to move forward.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data