Good afternoon everyone, I am currently trying to measure features on a tubed part. I have a 5 way that i am using but only using two tips. I thought my knuckle was working for a little bit and I use my master to calibrate both directions and then switch to my probe build and calibrate all tip 1 angles first then change to Y+ direction for the knuckle calibration and i thought the StdDev looked ok but everytime i try to measure the features at the bottom, it is giving me Very High Results. I measured the same part a month ago and all the features were in spec underneath and now i am measuring the same part and all the features say they are way out. I am totally confused by this and I've exhausted all options. Can someone please help? Attached are images of my probe build and setup.
Your second image has * asterisks next to a bunch of probe angles.
Those * asterisks indicate the probe angles haven't been calibrated yet.
Calibrate the probe (all angles) and any other probes you use to measure the part.
You might want to look into establishing a "Master Probe" if you haven't yet.
