I am looking to be able to run a program and call the measured data "Nominal" so that I can run our parts and compare it to the original that was sent from the customer.
Can I do this? I do recall there may be a setting for this but am unsure how to proceed.
I think you will need to F9 each feature and change it to MASTER then OK without measure now marked. Then the FIRST time the program is run, it will set the nominals to the touch it made and hold those nominals 'forever'.
I think you will need to F9 each feature and change it to MASTER then OK without measure now marked. Then the FIRST time the program is run, it will set the nominals to the touch it made and hold those nominals 'forever'.