"I am measuring this Ring Gage Manually both the Height and the Width. When I move the probe in the Y direction, I get a good Deviation from Nominal. Then I try doing hits in the X Direction and it’s showing out half a mil. But if I turn the Ring Gage in the Y direction to measure the other half, it comes out good. I hope I explained this well enough lol. Pretty much my X direction is showing out but when I rotate it to the Y Direction, it shows up good." I tried changing Wrist Angles and its still showing a half mil deviation. I am in contact with Hexagon but just wanted to see if anybody has ran into this problem before. I have attached an image.
Tater, This Ring Gage has no CAD. Its a measurement tool used for our parts out on the floor. It has no Datum Scheme either. Manual would be the only way to measure it. Unless anybody can give me any better ideas.