"I am measuring this Ring Gage Manually both the Height and the Width. When I move the probe in the Y direction, I get a good Deviation from Nominal. Then I try doing hits in the X Direction and it’s showing out half a mil. But if I turn the Ring Gage in the Y direction to measure the other half, it comes out good. I hope I explained this well enough lol. Pretty much my X direction is showing out but when I rotate it to the Y Direction, it shows up good." I tried changing Wrist Angles and its still showing a half mil deviation. I am in contact with Hexagon but just wanted to see if anybody has ran into this problem before. I have attached an image.
You neither need a CAD or datum structure to create your own prgm to check this in DCC, also have the tips been qualified as per the designated way, master probe, sphere moved etc, end of shift and my weekend starts now, best of luck, plenty of help on here if you search
You neither need a CAD or datum structure to create your own prgm to check this in DCC, also have the tips been qualified as per the designated way, master probe, sphere moved etc, end of shift and my weekend starts now, best of luck, plenty of help on here if you search