"I am measuring this Ring Gage Manually both the Height and the Width. When I move the probe in the Y direction, I get a good Deviation from Nominal. Then I try doing hits in the X Direction and it’s showing out half a mil. But if I turn the Ring Gage in the Y direction to measure the other half, it comes out good. I hope I explained this well enough lol. Pretty much my X direction is showing out but when I rotate it to the Y Direction, it shows up good." I tried changing Wrist Angles and its still showing a half mil deviation. I am in contact with Hexagon but just wanted to see if anybody has ran into this problem before. I have attached an image.
Take you manual hits and get the part location alignment.
switch mode to DCC in your program
take hits on the alignment features
do a 2nd, DCC, alignment
take hits on all the features you want to check
run the program
the machine will have you retake your manual hits and then it will take the hits on your part you made in the DCC section
Take you manual hits and get the part location alignment.
switch mode to DCC in your program
take hits on the alignment features
do a 2nd, DCC, alignment
take hits on all the features you want to check
run the program
the machine will have you retake your manual hits and then it will take the hits on your part you made in the DCC section