I am writing 2 programs that fixtures will be moved frequently.
My goal is I would like to prompt to ask - Has fixture been moved on CMM? ...something along those lines. So I can either skip the manual alignment OR run it while in protected mode for the techs.
How would I go about this? More Info can be provided and can post code if need to.
Protected mode won't let an operator re-mark the section for execution though. It would require making marked sets and still would require a prompt to determine the proper 'set' to measure.
Protected mode won't let an operator re-mark the section for execution though. It would require making marked sets and still would require a prompt to determine the proper 'set' to measure.