I am writing 2 programs that fixtures will be moved frequently.
My goal is I would like to prompt to ask - Has fixture been moved on CMM? ...something along those lines. So I can either skip the manual alignment OR run it while in protected mode for the techs.
How would I go about this? More Info can be provided and can post code if need to.
IF you can use a readpoint or double read point to start datum measurement, program will prompt "Ok to measure manual alignment features" reply YES if fixture has moved or NO if in same location.
IF you can use a readpoint or double read point to start datum measurement, program will prompt "Ok to measure manual alignment features" reply YES if fixture has moved or NO if in same location.