Hello Everyone.
We have a Hexagon Dual Z machine and we are using it for a lot of Tactile only measurement.
On a lot of parts we can't clearly see where the probe is due to the lack of light reaching the parts.
Is there any PC-DMIS command which can switch on the Ring light on the machine ?
Is it possible to use the Ring light as an extra light source when we are not using the vision system but the probing sensor only ?
Thanks for your reply in advance, and have a nice day
I don't know about dual z cmms, but I would check a parameter which switch off the light at the end of measurement (I don't remember if it's in F5, or in cmm interface (edit/preferences/machine interface setup)
I don't know about dual z cmms, but I would check a parameter which switch off the light at the end of measurement (I don't remember if it's in F5, or in cmm interface (edit/preferences/machine interface setup)