I am in the process of creating templates. The Help Center says the following:
Controlling What Ends Up in a Template
If you want to include only parts of your measurement routine as template commands, you can control that with some special start and end Document comments.
- Open a measurement routine that you want to use as your template.
- Locate the commands that you want PC-DMIS to insert into new measurement routines.
- Bound the commands you DO want to include these Document comments:
- #TEMPLATE_COMMAND_START_POINT#
- #TEMPLATE COMMAND_END_POINT#
Unfortunately I have no idea how to use these commands.
I can't paste them into the editor.
Thanks for the help in advance.
